Y

Bolt-On Bearing Hanger with Bearing for 5/8" OD Jackshafts Cast iron bearing hanger with bearing for 5/8" OD jackshafts and axles.Bearing collar has two setscrews to hold jackshaft or axle in place.Bearing pivots inside bearing holder for self-alignment so precise alignment of jackshaft and bearing hanger is not necessary. Pre-lubricated and has a grease fitting for relubrication.  Mounting bolt holes suitable for 7/16" or 10mm bolts. Length: 4.85" (123mm) Width: 1.28" (32.3mm) Height:...

Bosch Type Relay Wiring Connector with Harness

Bosch Type Relay Wiring Connector Socket with Mounting Tab

Bosch Type Wide-Pin Relay Wiring Connector with Harness

Bosch-Type Relay Wiring Connector Socket

Brake Cable Adjuster 6mm Threads 25mm Overall Length 18mm Thread Length

Brake Cable Adjuster with 10mm Threads Commonly used on the brake lever to adjust the brake cable tension. Aluminum brake cable adjusting barrel with adjustment stop nut. 26mm long x 12mm wide overall measurements not including the stop nut. Fits brake cable ends up to 6mm wide. Threaded area is 15mm long. M10 x 1.00 threads (10mm OD x 1mm pitch).

Brake Cable Adjuster with Mounting Boss Nickel plated steel brake cable adjusting barrel with mounting nut. Most commonly used on caliper type brakes. Fits brake cable housing ends up to 6mm wide. Brake cable adjuster has M6 x 1.00 threads (6mm OD x 1mm pitch). Mounting boss fits into 6mm mounting hole.

Brake Cable End CapSold individually.Made from aluminum alloy.12mm long, 4mm OD, 2.1mm ID.For brake cables up to 2mm OD.

Xiaomi M365 Electric Scooter Brake Cable

Brake Cable Housing Ferrule Sold individually.Made from nickel-plated brass.10mm long, 5.1mm OD, 5mm ID, 3.1mm cable hole.For 5mm OD brake cable housings with brake cables up to 3mm OD.