Y

Left and Right Hand Brake Levers with Parking Brake and Brake Switch Left and right hand three-finger pull brake lever set with parking brake. Apply the brake and then push on the black parking brake lever to set the parking brake. Apply the brake again to automatically release the parking brake. Steel parking brake lever. Aluminum brake lever with aluminum base. Built-in brake switch with 68" long cable and 2-Pin Black Wire Connector. Lever has return spring. High-profile design reaches over...

Pull Brake Switch with Two Mounting Nuts and Spring When switch plunger is pulled by the spring the brake switch turns on. Single-pole 2-wire brake switch. Switch is normally open and closes when the plunger is pulled.

70/80-6.5 Tubeless Tire for Electric Scooter Compatibility: To be determined. Related Parts Straight Valve Stem with 11mm Seat for Tubeless Tire

Pull Brake Switch Spring8-5/8" (220mm) overall length. Made from 1mm zinc-plated spring steel wire. One end has a preformed 180 degree bend in it and the other end can be bent at the exact point that it needs to be. 

Chain Breaker for #25 Chain, Zinc Plated Chain breaker for #25 chain.Made from yellow zinc-plated steel.

Brake Cable Stopper This cable stop is commonly used for go-kart brake, throttle, and clutch. Works with cables up to 2mm. Material: Steel Finish: White zinc-plated Cable hole diameter: 2mm Outside diameter of barrel: 8mm across flats Length of barrel: 9mm Thread type: M4x0.8 Threads accessible from both ends: YesDrive: Combination, Phillips and Flathead ...

5.5mm x 2.1mm Coaxial Charger Port with Wires and Connector Mounts into a 1/2" or 12mm round hole or a 12mm x 10.5mm double d-bore hole. Port dimensions: 5.5mm (~1/4") inside diameter x 2.1mm pin diameter.Replaces some CiQGY charger ports.  Compatibility: isinwheel S9 Electric ScooterTurboAnt M10 Lite Electric ScooterTurboAnt M10 Pro Electric ScooterMoovway B19 and B20 Electric BikeWindgoo B19 and B20 Electric Bike ...

5.5mm x 2.5mm Metal Coaxial Charger Plug 5.5mm x 2.5mm male coaxial charger plug. Prong dimensions: 14mm (~1/2") long x 5.5mm (~1/4") outside diameter x 2.5mm inside diameter.

12 Piece Glueless Tube Repair Patch Kit Glueless tube patches eliminate the need to carry and use a tube of rubber cement to patch a tube. How To Install Clean and buff tube lightly where the patch will be applied to the tube. Peel liner from the back of the patch, Press patch on tube firmly for two minutes.  This Kit Contains Ten 1" round glueless tube patches.One steel inner tube scuffer.One plastic carrying case. ...

2 Port or 3 Port House Charger Plug to 3 Port Inline Plug Battery Charger Adapter Converts 2 vertical port house plug to 3 port (3P) inline plug. Converts 3 vertical port house plug to 3 port (3P) inline plug. Converts 2 vertical 1 horizontal (2V1H) port house plug to 3 port (3P) inline plug.

10x2.50 Electric Scooter Tube with 45 Degree Bend 90 Degree Angle Valve Stem 10x2.50 Inner Tube (For 10x2.5, 60/80-6, or 60/85-6 tires.)45 Degree Bent 90 Degree Angle Valve Stem Compatibility:Glion DollyXL Electric ScooterPlus many other makes and models.

Axle Sprocket for Razor Dune Buggy 32 Teeth