Products 1285-1296 of 5872
Show
Availability: In Stock
ESP
Item #: KIT-361000-06 -
Wire Routing Select the wire lengths of the kit above. The motor in this kit has an 11-tooth sprocket for 8mm chain and a 10-tooth motor sprocket for #35 chain is included with this kit. We have wheel and axle sprockets for all chain sizes which are compatible with this kit. We also have sprockets for #41 and #420 chain which fit the motor in this kit. Click below to view our full selection of sprockets and chains. Sprockets Chains ...
Availability: In Stock
ESP-CHANGE-TO-CONTACTOR
Item #: KIT-159 -
Wire Routing The motor has an 11 tooth sprocket for 8mm chain factory installed onto it and a 10 tooth sprocket for #35 chain is included with this kit that fits directly onto the motor and can replace the sprocket for 8mm chain. Power off, power on forward, and power on reverse are activated by the three position key switch.The reverse relays will be wired close to the controller so they can be mounted in the same area. We have motor sprockets for #420 chain which fit the motor in this kit....
Availability: In Stock
SH
Item #: MOT-361000 -
36 Volt 1000 Watt Electric Scooter Motor 36V 1000W 3000 RPM electric scooter motor. Powerful four brush permanent magnet design with 100% ball bearing construction. 15" long power leads. Shaft rotation reversible by reversing power leads. Includes factory installed 11 tooth sprocket for 8mm chain. Different size sprockets are available for this motor. Motor shaft starts at 12mm OD and is stepped down to 10mm OD with two flat spots that are 8.5mm apart where the sprocket mounts, past the...
Availability: In Stock
SH
Item #: MOT-361000B -
36 Volt 1000 Watt Electric Scooter Motor 36V 1000W 3000 RPM electric scooter motor. Powerful four brush permanent magnet design with 100% ball bearing construction. 18" long power leads. Shaft rotation reversible by reversing power leads. Includes factory installed 11 tooth sprocket for 8mm chain. Different size sprockets are available for this motor. Dimensions: 4-1/4" wide x 6" long excluding shaft, 7" long including shaft. Mounting bracket measures 4-3/4" x 2-7/8" and has 4 holes that...
Availability: In Stock
ESP
Item #: KIT-361000-05 -
Battery Jumper Wires = 5" LongBattery to Speed Controller Connector Wires = 24" long The motor in this kit has an 11 tooth sprocket for 8mm chain. We have wheel and axle sprockets for 8mm chain which are compatible with this kit. We also have sprockets for #25, #35, and #420 chain which fit the motor in this kit. Click below to view our full selection of sprockets and chains. Sprockets Chains ...
Availability: In Stock
ESP
Item #: KIT-361000-08 -
Wire Routing Chart The red button on the throttle is the On/Off power switch.The throttle has battery indicator lights which let you know how much capacity is left in the battery pack and also when the power is on or off. Select the wire lengths of the kit above.
Availability: In Stock
SH
Item #: MOT-SD361000DD -
36 Volt 1000 Watt Motor with Gearbox and Axle for eZip and IZIP 1000 Series Direct Drive Electric ScootersFits the following makes and models: eZip 1000 and E-1000 IZIP 1000 and I-1000 Schwinn Stealth 1000, S1000, and ST-1000 with 15mm Axle Included wire and wire connector (not shown in photo). Compatible only with 1000 series scooters that have a direct drive gearbox transmission. Dimensions PDF Important Information: For Schwinn 1000 series scooters with 15mm rear wheel axle only. Does not...