The connector with single yellow wire is optional to connect and the controller will operate normally with it not connected to anything. This connector is for newer scooter versions which disable operation of the motor when the battery pack is charging, however, this controller is backwards compatible with older scooter versions which have controllers without this connector.Fits the following makes and models: eZip 150 ScooterGT GT-200 Scooter IZIP 130 ScooterIZIP 135 ScooterIZIP 150...
Controller For eZip 4.0 and 4.5 Electric Scooter (CTE-24251)
9 Tooth 11mm Bore Sprocket for 1/2" x 1/8" Bicycle Chain Motor sprocket with key pin for MY1016Z, MY1016Z3, and MY1018Z gear motors. 1-5/8" (41mm) OD, 11mm ID, 4mm wide x 2mm deep keyway. 9mm wide hub. For 1/2" x 1/8" (#410) bicycle chain. Fits Currie® Electro Drive electric bicycle kits plus eZip® and IZIP® electric bicycles with gear motors. Spare keys are available on our 4mm x 4mm x 8mm Key Pin for Keyed Motor Shaft Sprockets page ...
Motor to Rear Wheel Chain for eZip, IZIP, and Currie Electric Bicycles28 Links of #410 (1/2" x 1/8") bicycle chain with a master link.
Motor Plate For Currie Electric Bicycles (CTE-24367)
V-Brake For Currie Electric Bicycles (CTE-24370)
PAS 24 Volt Speed Controller For Currie Electric Bicycles (CTE-24371)
Rear Shifter For Currie And Izip Electric Bicycles (CTE-24374)
Rear Wheel Sprocket For Currie Electric Bicycles (CTE-24375)OD is 3-3/8", ID is 1-3/8"
Battery Terminal Cover For Currie RMB Electric Bicycles (CTE-24380)
Battery Pack for IZIP, Mongoose, and Schwinn Electric BicyclesFits the following models: IZIP AL-1020IZIP CB24X450IZIP CB26IZIP EzGoIZIP Via Mezza Mongoose CB24V450Mongoose CX24V450Schwinn AL-1020Schwinn IZIP Men'sSchwinn IZIP Women's