CTE

24 Volt 450 Watt 2400 RPM Currie Electric Scooter Motor with 11 Tooth Sprocket Specifications: 24V (DC24V), 450W, 2400RPM (R/MIN), 28A, Base Mount Rated Current: 28A Model: XYD-6D (Use model plus specifications to determine compatibility.) Powerful four brush permanent magnet design with 100% ball bearing construction. 11 tooth sprocket for #25 chain. Shaft rotation spins clockwise if you are facing the shaft. Shaft rotation reversible by reversing power leads. 14" long 12AWG power leads with...

Speed Controller for IZIP Zuma Electric Bicycle

Speed Controller For Currie Electric Scooters (SPD-SD1501)

eZip, IZIP, and Currie Tech Electric Bicycle Speed Controller This controller can be used to replace many eZip and IZIP electric bicycle controllers that have pedal assist (PAS), however, the pedal assist switch and function will be deleted after this controller is installed so only the throttle controls the speed of the motor. This controller has one handlebar brake lever connector. If a controller with two handlebar brake lever connectors is needed then in the Choose Your Options box above...

24 Volt Speed Controller with 5 Wire Throttle Connector for eZip, IZIP, Currie, Schwinn, Mongoose, and GT Electric Scooters and Bikes Designed for 24 Volt 500 Watt and 600 Watt motors.Outputs 720 Watts so it can be used with 750 Watt motors however the motor's power will be limited to 720 Watts.Maximum current 30 Amps. Under Voltage protection 20.5 Volts. Current limiting feature helps prevent controller and motor damage due to over-current conditions. Under voltage protection feature prevents...

55 Tooth Rear Sprocket For #25 Chain (SPR-C2555)Replaced with SPR-2555B.

Currie Electric Scooter Seat Tube with Seat Post Clamp 28.6mm (~1-1/8") OD25.4mm (1") ID28.6mm Seat Post ClampBlack Enamel FinishIncludes Seat Post ClampDoes Not Include Seat Post (Compatible With 25.4mm OD Seat Posts)

Twist Throttle with Power Meter for 24 Volt eZip®, IZIP®, Schwinn®, GT®, and Mongoose® Electric Scooters and Bikes (5 Terminal Connector) For Currie®, eZip® , IZIP®, Schwinn®, Mongoose®, and GT® electric scooters and bicycles. Three LED indicator lights, low, half and full. Wire colors: orange, black, red, blue, gray. 45" long throttle cable with connector. To determine the correct throttle for your electric scooter or bike select your model. Replaces newer version throttles with orange,...

Twist throttle with battery indicator lights and green on/off push button switch for the IZIP Zuma Cruiser electric bike.THR-700http://www.electricscooterparts.com/izipzumacruisermenselectricbikeparts.htmlhttp://www.electricscooterparts.com/izipzumacruiserwomenselectricbikeparts.html ...

Four Wire Twist Throttle for: eZip 150 ScootereZip EZ2 Nano Scooter eZip EZ3 Nano Carver Scooter GT GT-200 Scooter IZIP 130 ScooterIZIP 135 ScooterIZIP 150 ScooterIZIP 200 ScooterMongoose M-130 ScooterMongoose M-150 ScooterMongoose M-200 Scooter Schwinn S150 Scooter Schwinn S200 Scooter 45" long wire cable.

Rear Wheel for Currie Electric Scooters 200x50 8" OD tire. 55-tooth chain sprocket. 60mm band brake. Axle with bearings, spacers, and mounting hardware. Currie part # WH-08R-002. Compatibility: eZip E-4.5 Electric Scooter May be compatible with other eZip, GT, IZIP, Mongoose, and Schwinn electric scooters.