Shared

18 Volt 1.8 Amp Automatic Battery Charger with RCA Plug

Half Length Twist Throttle with Connectors Half twist throttle with 24 Volt battery indicator and connectors. Plug-and-play compatible with the following controllers: SPD-24150 Speed ControllerSPD-24250 Speed ControllerSPD-24350B Speed ControllerSPD-24500B Speed ControllerSPD-24500R Speed ControllerSPD-241000 Speed Controller Matching Grip Set: GRP-54 Handlebar Grips for Half Length Twist Throttles ...

JAK Super Brake Disc Brake Caliper with Brake Pads JAK Super Brake disc brake caliper with brake pads. Compatible with many newer version electric scooters, electric bikes, and electric go-karts For 2mm thick rotors. Cable pull arm points to the left side when looking at front of caliper. 2" (51mm) center to center distance between mounting bolts. Includes pre-installed brake pad set.Not all JAK brake calipers have the JAK logo printed on them and they are made in black and red colors so your...

Battery Charger for 24 Volt LiFePO4 Batteries, 29.4V 2A Output, with 4-Pin XLR Plug Specifications: Input Power: 100-240VAC Output Voltage: 29.4V (29.4 Volts) Output Amperage: 2A (2 Amps / 2000mA) Output Plug: 4-Pin XLR Wired with #1 Pin Positive, #2 Pin and #3 Pin Negative Compatibility: EV Rider Gypsy Electric Scooter ...

Primary Belt for eGO Electric Scooter Primary drive belt for the eGO electric scooter. This is the belt that goes between the motor and the jackshaft.

Secondary Belt for eGO Electric Scooter Secondary drive belt for the eGO electric scooter. This is the belt that goes between the rear wheel and the jackshaft.

Jackshaft Bearing Set for eGO Electric Scooter Set of two premium quality sealed bearings for the eGO electric scooter jack shaft.

16 Tooth Freewheel Sprocket with 11mm Bore Adapter for 1/2" x 1/8" Bicycle Chain Motor sprocket for our 250-450 Watt gear motors.Right-hand thread 16-tooth freewheel with M35x1.00 threads.The motor shaft must rotate clockwise to use this sprocket.Includes steel freewheel sprocket and adapter.Freewheel is threaded onto the adapter and is replaceable. 2-3/8" (57mm) OD, 11mm ID, 4mm wide x 2mm deep keyway.Works with 1/2"x1/8" (#410) bicycle chain. Installation Example ...

Throttle for Currie Electro Drive Electric Bicycle Conversion Kit Replaces Currie Technologies TH-DZBZX-001 throttle. View All Currie Electro Drive Electric Bicycle Kit Parts

Thumb Throttle for Razor EcoSmart Metro Electric Scooter With plug-and-play connector for the Razor EcoSmart Metro. Three LED battery battery level indicator.The original throttle uses a half length grip so a new full length grip set such as GRP-18SET should be installed along with this throttle. 

36 Volt 1000 Watt Motor with Gearbox and 15mm Axle for Schwinn Stealth, S1000, and ST-1000 Direct Drive Electric Scooters Fits the following makes and models: Schwinn Stealth with 15mm Axle Schwinn S1000 with 15mm Axle Schwinn ST-1000 with 15mm Axle Included wire and wire connector (not shown in photo). Compatible only with scooters that have a direct drive gearbox transmission. Dimensions PDF Important Information: For direct drive Schwinn scooters with 15mm rear wheel axle only. Does not...

JAK Super Brake Disc Brake Caliper with Brake Pads JAK Super Brake disc brake caliper with brake pads. Compatible with many newer version electric scooters, electric bikes, and electric go-karts For 2mm thick rotors. Cable pull arm points to the left side when looking at front of caliper. 2" (51mm) center to center distance between mounting bolts. Includes pre-installed brake pad set.Not all JAK brake calipers have the JAK logo printed on them and they are made in black and red colors so your...